The driver side fender was original but the since the passenger side fender was replaced with a new aftermarket , it did not have the emblem holes pre-drilled.
To make sure it matched the other side, I placed a piece of card stock from a cereal box along the ridge and marked the holes for a template. It would probably be easier to make the template based on the original passenger side fender.
{CAPTION}Then I reversed the card stock and placed it on the other side to mark where the holes need to be drilled.
{CAPTION}

I double check the marked areas lined up with the emblem before drilling.
{CAPTION}

Drilled the holes and assembled!

{CAPTION}